[Music] we recommend this product be installed by a competent gunsmith modification of your firearm may nullify the warranty of the firearms manufacturer no liability is expressed or implied for damage or injury which may occur from improper use or installation of this product you are responsible for the safe handling legalities and use of your firearm warning always wear safety glasses when working on firearms hi guys Scott folk here from apex tactical specialties today I'm going to walk you through the installation of the apex ultimate striker plunger for the Glock pistols for this installation you're going to
need a 3/32 inch pin punch or a Glock Armorer's tool to replace the striker plunger we need to remove the backplate first so first we need to go in here between the striker face itself and the stripper rail and find the little plastic sleeve that is the housing around the striker I'll press down against spring tension for my thumb all the way over the top and slide the backplate off that little pop you heard was the extractor spring popping up that's normal keep your thumb over the top so you don't lose that I'll put my
thumb back over the top and slide the back lid off the next one you're here is the striker sleeve popping up against my hand with those detentions I can remove the components as needed to remove the striker plunger I need to take the extractor out of the way first I need to remove the extractor spring so I'll pull the extractor spring and plunger back giving me space to push the extractor out I'll come in here and I'll press on the striker plunger I'll press that guy down and I'll go ahead and pull the extractor into
the breech and let it fall out we'll put that back in later I'll go ahead and put my finger in here and hold the striker plunger down and I'll pull this striker out about an inch or so to get it out of the way now I can relieve tension on the striker plunger and now I can remove it from the slide as needed to replace it I want to show you the differences between the factory component in the apex striker plunger you'll see the factory component has kind of a bevel on the end it's kind
of a dull finish the apex striker plunger has a nice radius surface on the end and is also very well polished this is intentional to give you a nice smooth uptake and trigger pull to install the apex striker plunger we'll take the factory spring we'll push it into the striker plunger sometimes it'll click in place sometimes alone it's not really critical if it does or not take the slide drop the plunger into the slide make sure that spring gets where it needs to go I'll press it all the way up and hold it in position
I'll take the extractor I'll set it over the top I'll put it in position now I can let go attention on the striker plunger and I'll hold itself in place now we can put the rest of the components back together with the striker plunger in position and the extractor reset holding it in place all we need to do now is push the striker all the way in against the striker plunger and make sure the extractor plunger is seated against the extractor now we can put the backplate back on to reinstall the backplate all I'll do
is take the backplate put it against the slide and I'll hold it with my thumb just in position I'll press on the striker sleeve under spring tension press that guy down until I can get the back plate over it that'll hold the striker in place now I have to compress the extractor spring while I push the back plate up once I'm there I can pull my punch out and lock the back plate in place now that we have the striker plunger installed we're gonna go ahead and do a functions check I'll pull back on the
striker just a little bit take tension off make sure the striker plunger moves up and down smoothly I'll press it in I'll let the striker forward and I'll actually press it forward and I want to see that the striker is going through the breech this verifies that I'm actually able to fire it I'll release it pull it back striker plunger should pop up I push forward I get no movement of the striker going forward which is proper operation installing the striker plunger is a very straightforward process if you have any questions contact apex customer service
that's what we're here for [Music]